12/13/2023 0 Comments Airflow helm chart![]() ![]() ![]() If using a custom StorageClass, pass name here. Low values cause more traffic to the remote git repository.Įnable persistent volume for storing dags. High values are more likely to cause DAGs to become out of sync between different components. Interval between git sync attempts in seconds. Git sync container run as user parameter. Subpath within the repo where dags are located. Name of a Secret containing the repo sshKeySecret. Securit圜ontext : runAsGroup : 0 runAsUser : 50000 You can bake a webserver_config.py in to your image instead or specify a configmap containing the webserver_config.py. This string (can be templated) will be mounted into the Airflow webserver as a custom webserver_config.py. The Fernet key used to encrypt passwords (can only be set during install, not upgrade). Overrides tag.ĭefault airflow repository. Settings to go into the mounted airflow.cfgĭefault airflow digest to deploy. $ helm install MY-RELEASE oci:///tac-for-tanzu-advanced/charts/airflow -set "global.Airflow_local_settings file as a string (can be templated).Īirflow version (Used to make some decisions based on Airflow Version being deployed). **If you are using Helm CLI version 3.7.x (please note `export HELM_EXPERIMENTAL_OCI=1` is not needed from 3.8.0 onwards)** $ helm install MY-RELEASE airflow/ -set "global.imagePullSecrets=SECRET-NAME" $ helm chart export /tac-for-tanzu-advanced/charts/airflow:latest $ helm chart pull /tac-for-tanzu-advanced/charts/airflow:latest **If you are using Helm CLI version older than 3.7.0** Replace the SECRET-NAME placeholder with the same Kubernetes ImagePullSecret name used previously. If using VMware Application Catalog for Tanzu Advanced, use the commands below to deploy the chart instead. $ helm install MY-RELEASE appcatalog/airflow The name must start and end with a lower-case alphanumeric character and can only contain alphanumeric character, '-' or '.'. Replace it with the name you want to give to the deployment or add the -generate-name parameter to automatically generate a name. NOTE: Remember that MY-RELEASE is a placeholder. The "release" includes files with Kubernetes-needed resources and files that describe the installation, configuration, usage and license of a chart.Ĭheck that your Kubernetes cluster is running by executing the following command: $ kubectl cluster-infoĭeploy the chart with the following command: $ helm registry login /tac-for-tanzu-advanced/chartsĪ Helm chart describes a specific version of a solution, also known as a "release". $ kubectl create secret docker-registry SECRET-NAME \ Replace the USERNAME and TOKEN placeholders with the correct registry credentials and the SECRET-NAME placeholder with a custom name for the secret. If using VMware Application Catalog for Tanzu Advanced, it is necessary to first create a Kubernetes ImagePullSecret for /tac-for-tanzu-advanced with the registry credentials, and then log in to the registry with the registry credentials. ![]() $ helm repo add appcatalog REPOSITORY -username "USERNAME" -password "PASSWORD" Replace the USERNAME and PASSWORD placeholders with the correct username and token and the REPOSITORY placeholder with a reference to your VMware Application Catalog chart repository. Follow these steps:Īdd the VMware Application Catalog repository to Helm with the following command. To start using any VMware Application Catalog Helm chart, it is necessary to first add the VMware Application Catalog Helm chart repository to Helm and then run the helm install command to deploy this chart. NOTE: To install a Helm chart repository, it is necessary to have Helm previously installed and configured in your cluster. Apache Airflow packaged by VMware - Install the chart ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |